Grouts and Anchor Grouts

Anchor Grout Is Polyester Resin Based Grout Material Suitably Blended With A Hardening Compound And Fillers And Supplied As A Pre Measured, Two-Part, Resin Grout. After Hardening, The Grout Has High Mechanical Properties. Anchor Grout Is Used Where The Difference Between The Hole Diameter And Bar Diameter.

Get Started

Grouts & Anchor Grouts DOV® GROUT N

Normal strength non-shrink free flowing grout for industrial applications. Only water need to be added. Typically suited for grouting of foundation bolts and base plates of industrial machines. Also useful for bore packing in upper floor toilets to ensure water tightness and firm fixing of pipes.

Grouts & Anchor Grouts DOV® GROUT H

High strength, non-shrink free flowing grout for industrial applications. Only water needs to be added. Typically suited for grouting of foundation bolts and base plates of industrial machines. Also useful for bore packing in upper floor toilets to ensure water tightness and firm fixing of pipes.

Grouts & Anchor Grouts DOV® ANCHOR GROUT

Rapid setting two component polyester resin grout for anchoring bolts and rebar’s. High initial strength gain permits rapid installation and early application of load. Useful for grouting of rebar’s for concrete extensions.

Frequently asked questions

  • Apply one coat of Dovcoat Flex (diluted with water @ 500ml per Kg) at the rate of 10-12 m2 per liter.
  • Allow it to dry for 2-3 hours.
  • Apply the first coat of Dovcoat Flex diluted with water @ 250ml per Kg) at the rate of 2 m2 per Kg and allow it to dry before taking up the second coat, the rate of application being the same.
  • Drying time between coats will be 6 to 8 hours.
  • Ensure that the primer and the 2 coats of Dovcoat Flex totally achieve a minimum thickness of 1 mm DFT.
  • Allow the system to air cure for 7 days minimum

Cracks in concrete must be repaired as soon as possible. 

  • Waterproofing: It will solve the water-dripping problem immediately using DOV Crack filler, If the rains have already begun, get the roof waterproofed and later get the proper work done.
  • DOV Crack filler with DOV Flex waterproof coating: I personally suggest you to go for this. It takes less time and is a proper permanent and suitable method. The method includes:
  1. Cleaning of the crack surface and removing any type of oily dirt or contaminants.
  2. Widen the crack just a little to allow the grouting to occur at a faster pace.
  3. Fill the DOV crack filler in the cracked surface (or  DOV  Epoxy Injection) and seal the surfaces immediately to prevent epoxy gel from falling off. If Epoxy grouting cannot be done, you can do the same using DOV Flex with water, ONLY if the crack is shallow and not widening. When the gel dries up properly, paint the roof to give it a proper finish and to protect it from dust and water.

Hope this helps.